WAFER GSM-CTL-AC REMOTE CONTROL UNIT
http://www.waferstar.com
The following compand is used in the GSM-CTL-AC :
#PWD
:
Password
#CAP
:
Change
password
#WHL
:
White List (add or remove numbers)
#GOT
:
Relay working output delay time
#ALARM
:
Alarm information setting
#MODE:
Relay mode
#CSQ
:
Check
Signal
Quality
#SCA:
Set service center address
#STATUS
:
Check status
Once you issue a command with an SMS, you will receive a confirmation SMS with OK
if everything is correct or Err if there is an Error.
GSM-CTL-AC SMS COMMAND LIST:
#PWD Password.
This command must always come first 6 digits as a password.
The standard default one, when the device comes from the factory, is 123456.
We suggest that you change it, using the #CAP command.
In all the following examples we will use 123456 as an example of password.
#CAP Change Password.
Use this command to change the password with a new one that you will chose for your device
( don't forget it or you will have to send the unit back to us to reset it, and this has a cost )
The #CAP command must be issued 2 times to be sure you don't digit a wrong one.
OF course it must be preceded by the old password.
For example, to change the password 123456 into the new password 333444 you need to send the
following SMS:
#PWD123456#CAP333444#CAP333444
Acknowledge SMS: PWD SETUP OK
If you wrote correctly, or an Error message if you made a mistake.
If the old password is error,then conformation would be :
Error Old Password
If you input two different new password,then reply would be :
Error New Password,Please Check the
input again
#WHL White List
.
This is the command that you will use most. it is used to add or remove numbers that are enabled
to control the relay sets into the White List. You can add up to 200 numbers in the list. Every
position must be indicated in the command and we advise you to keep a list written somewhere to
know which numbers are in and in which position.
• To add a number, the syntax of the command is the following:
#PWD123456#WHL01=61143815
Acknowledge
would be :
WHL01 SET TO 61143815 OK
Where 01 is the position in the list and 61143815 is the number enabled.
