Waeco PerfectView M70IP, Installation And Operating Manual, Page: 35 / 280

PerfectView M70IP Installing the LCD monitor
EN
35
z
Check beforehand that there is sufficient space on the other side for the drill head to
come out (fig.
2
, page 4).
z
Bear in mind the weight of the monitor. Provide reinforcement if necessary (larger
washers or plates).
z
Make sure you can lay the connection cable to the monitor.
Choosing the installation location (fig.
b
, page 7)
➤
Slide the monitor ( 1 ) onto the monitor bracket ( 2 ) and secure it with the knurled
screw ( 3 ).
➤
Position the monitor with the attached monitor bracket provisionally.
➤
Mark the outlines of the corners of the monitor bracket ( 2 ) on the dashboard.
➤
Unscrew the monitor from the monitor holder.
I
Sticking the monitor bracket onto the dashboard (fig.
c
A, page 7)
➤
Remove the film from under the monitor bracket.
➤
Stick the monitor bracket to the position of your choice.
Screwing the monitor bracket onto the dashboard (fig.
c
B, page 7)
➤
Hold the monitor bracket within the outlines marked beforehand.
➤
Mark four drilling points.
➤
Drill the holes, with
∅
of 2 mm, at each of the markings.
➤
Screw the monitor holder on using 4 x 20 mm self-tapping screws.
Fastening the monitor
➤
Set the monitor on the monitor bracket and secure it with the knurled nut (fig.
b
,
page 7).
NOTE
You can fasten the monitor bracket using adhesive or screws.