Waeco PerfectView M59L, Installation And Operating Instructions Manual

Page: 47 / 248

PerfectView
Installing the LCD monitor
47
8.2 Installing the monitor
d
Warning
Select the location of the monitor so that it cannot injure the pas-
sengers in the vehicle under any circumstances (e. g. sudden brak-
ing, road traffic accidents).
Observe the following installation instructions:
z
Select an installation location that provides an unobstructed view of the
monitor (fig.
e
, page 8 and fig.
f
, page 8).
z
Never install the monitor in an area where your head could knock against
it or in the air bag deployment path. This could cause injury if the airbag
opens.
z
The monitor must not impair your vision when driving (fig.
g
, page 8).
z
The installation location should be flat.
z
Ensure that the contact area between the monitor base and the installa-
tion surface is as large as possible.
z
Check that there is sufficient space underneath the installation location to
attach the washers and nuts.
z
Check beforehand that there is sufficient space on the other side for the
drill head to come out (fig.
2
, page 4).
z
Bear in mind the weight of the monitor. Provide reinforcement if necessary
(larger washers or plates).
z
Ensure that you can lay the connection cable to the monitor.
To perform the installation, proceed as follows:
Fasten the monitor to the monitor base (fig.
h
, page 9)
➤
Fasten the monitor (fig.
h
1, page 9) to the monitor base (fig.
h
2,
page 9) by leading the top of the base through the opening on the rear of
the monitor fig.
h
3, page 9).
➤
Fasten the monitor and the monitor base with the aid of knurled screws
(fig.
h
4 und 5, page 9).
_M59L_EB_10s.book Seite 47 Dienstag, 22. Januar 2008 4:59 16