Installation
Page 12
LCD MONITOR CABLING DIAGRAM
DTF-521, rear view
– B –
DC IN
(12V)
– A –
VGA cable
Video card
Rear panel of your computer
ANALOG
RGB
OUT
Do not attach the USB data
cable until instructed to do so.
Power adapter
– C –
To AC outlet
C
AUTION
Use only the power adapter that came with the DTF-521;
use of an improper power
adapter may damage the unit.
Do not connect or disconnect the video or power cables while the DTF-521 or your
computer are turned on –
this can damage the display or computer video card.
Make sure that the display refresh rate does not exceed 70 Hz for XGA mode, or 75 Hz
for other modes.
ANALOG
RGB
IN
VGA port
The
ANALOG
RGB
OUT port is used
to connect a second VGA device
such as a projector or monitor that
mirrors the pen display. Be sure to
fully install the DTF-521 hardware
and software before connecting a
projection device to the unit. Do not
connect or disconnect any cable
while the DTF-521 or your computer
are turned on.
DTF521.book Page 12 Friday, November 16, 2007 3:26 PM