Your new DTF-521
Page 8
INTERACTIVE PEN DISPLAY COMPONENTS
Your product has many features and components with which you will want to become familiar.
FRONT VIEW
The display and tablet sensor function as an integrated output and input device. The display supports
resolutions up to 1024 x 768 pixels at 16.2 million colors. The tablet sensor reports pen coordinates,
pressure, and switch information.
On Screen Display (OSD) controls
These controls, located on the upper
edge of the tablet, enable you to adjust
a variety of display settings. See
Adjusting the display
on page 27 for
more information.
Power LED
Lights blue when power has been supplied to the DTF-
521 and a video signal is present.
Glows orange when no video signal is detected by the
DTF-521. (e.g., Your computer is turned off, starting up,
or has entered a power management mode in which
video signals are not sent.)
Power switch
Turns power to the unit on or off.
Status LED
Lights blue when the pen is in
the active area of the pen
display tablet and the pen tip
is pressed. Note that the USB
cable must also be plugged
into an active USB port before
the LED will light.
Integrated display and tablet
Use the integrated USB
ports (one located on each
side of the unit) to connect a
USB device (e.g., a USB
Flash Drive or a USB remote
controller).
Be sure to fully install the
DTF-521 hardware and
software before connecting
any other devices to the unit.
Pen tray
Provides a convenient resting place for the pen. When the display stand
is set to its lowest position, place your fingers beneath the tray (located
on the bottom front edge) and slide it out.
DTF521.book Page 8 Friday, November 16, 2007 3:26 PM
