Wacker Neuson LTS4K, Operator'S Manual

Page: 15 / 84

wc_si001097en.fm
15
LTS Safety Information
Operation

For operators’ safety, the grounding of the machine always needs to be done
paying attention on the section of the cable to be used (never to be less than
10 mm
2
). For the connection of the grounding cable, please always use the clip
located on the front/right angle of the machine, near the jack.

Keep the area under and around the lights clear of people while raising and
lowering the tower.

The machine must be leveled and outriggers extended before raising the tower.

Do not move the Light Tower while it is operating or while the tower is raised.

Before carrying out any welding on the machine, ALWAYS make sure to
disconnect batteries and alternator leads.

The tools must NOT come into contact with the battery terminals with the risk of
creating an electric arc.

Use jumper cables only as recommended. Improper use can result in severe
damage and safety risk.

Never operate lights without protective lens cover in place or with a lens cover
that is cracked or damaged.
After use

Stop the engine when the machine is not being operated.

Close the fuel valve on engines equipped with one when the machine is not
being operated.

Ensure that the machine will not tip over, roll, slide, or fall when not being
operated.

Store the machine properly when it is not being used. The machine should be
stored in a clean location out of the reach of children.

Lower the tower when not in use, or if high winds or electrical storms are
expected in the area.

The lamps become extremely hot in use! Allow the lamp and fixture to cool 10–
15 minutes before handling.