Safety Information
LTN 6L
12
wc_si000227gb.fm
1.3.1
Do not remove, defeat, deface, or render inoperable any of the safety
devices, warnings, or labels on this equipment. If any safety devices,
warnings, or labels have been removed, defeated, defaced, or
rendered inoperable, do NOT use this equipment!
1.3.2
The area immediately surrounding the Light Tower should be clean,
neat, and free of debris.
1.3.3
Be sure the machine is on a firm, level surface and will not tip, roll,
slide, or fall while operating.
1.3.4
NEVER start a machine in need of repair.
1.3.5
Lower the tower when not in use, or if high winds or electrical storms
are expected in the area.
1.3.6
ALWAYS make certain the machine is well-grounded and securely
fastened to a good earthen ground per national and local regulations.
1.3.7
The tower extends up to 9 m (30 ft.). Make sure the area above the
trailer is open and clear of overhead wires and obstructions.
1.3.8
The lamps become extremely hot in use! Allow the lamp and fixture to
cool 10–15 minutes before handling.
1.3.9
Keep the area behind the trailer clear of people while raising and
lowering the tower! Never raise, lower or turn the tower while unit is
operating!
1.3.10
The trailer must be leveled and the outriggers extended before raising
the tower. The outriggers must remain extended while the tower is up.
1.3.11
If for any reason any part of the tower hangs up or the winch cable
develops slack while raising or lowering the tower, STOP immediately!
Contact an authorized Wacker Neuson service representative.
1.3.12
NEVER remove the tower locking pin while the tower is up!
1.3.13
NEVER use the machine if the insulation on the electrical cord is cut or
worn through.
1.3.14
NEVER operate the lights without the protective lens cover in place or
with a lens cover that is cracked or damaged!
1.3.15
NEVER adjust the tower while the unit is operating.
1.3.16
Do not move the Light Tower while it is operating.
1.3.17
NEVER raise the tower or operate the machine in high winds.
1.3.18
NEVER connect machine to other power sources, such as supply
mains of power companies.
1.3.19
ALWAYS replace or repair electrical components with components
that are identical in rating and performance as the original component.
