Wacker Neuson G 100, Operator'S Manual, Page: 55 / 98

G 100 / G 120 Operation
wc_tx001687gb.fm
55
4.19 Current Overload Fault
Along with engine functions, the ECM continuously monitors the current load in
each phase. The values for current overload are programmed into the ECM at the
factory and are different for each generator size.
1. When an overcurrent condition is sensed in any leg, the warning/fault LED (d)
will flash and the display will indicate OVERCURRENT.
2. If the overcurrent condition persists, the main circuit breaker (a) will open and
the display will change to OVRLOAD - SET BRKR. This indicates an overload
fault.
3. To clear the overload fault, reset the main circuit breaker. Failing to reset the
main circuit breaker will cause the machine to shut down after 5 minutes. The
display will then change to OVERLOAD.
4.20 Event Log
The control module contains an event log that records the first and last
occurrences of pre-alarms and alarms. See
Using the LCD and Keypad for
instructions on how to access the event log.
wc_gr008167
A Ø HZ
V
R B
a
s le
r
DIAGNOSTICS
DIAGNOSEN
DIAGNOSTICOS
DIAGNOSTICS
AUS AUS
APAGADO APAGADO
ARRET ARRET
OFF OFF
REMOTE START REMOTE START
FERNSTART FERNSTART
ARRANQUE REMOTO ARRANQUE REMOTO
DEMARRAGE A DEMARRAGE A
DISTANCE DISTANCE
START / LAUFEN START / LAUFEN
ARRANQUE / MARCHA ARRANQUE / MARCHA
DEMARRER / MARCHE
DEMARRER / MARCHE
START / RUN START / RUN
d
a