Wacker Neuson E 3000 LB, Operator'S Manual, Page: 122 / 214

wc_tx002070gb.fm
122
Burner Setup—Gas E 3000
7.3 Setting up the Burner
Background The burner consists of several different components and subsystems. Each of
these components or subsystems must be operating correctly for the burner to
function properly.
Tools required The following tools are required to adjust the burner:
„
High-quality combustion analyzer
„
Smoke spot tester
„
Manometer
„
General hand tools
Mandates
„
Adjustments made shall be done so that the machine conforms to the
requirements of local, state, and federal codes and authorities.
„
Adjustments shall be made at the job site.
When to
adjust Adjust the burner:
„
Before operating the machine at elevations 305 m (1,000 ft) above or below the
location of where the last adjustments were made
„
Before starting at a new job site
„
After any burner maintenance or repair has been performed
„
If burner performance is in question
Procedure Follow the procedure below to set up the burner.
1. Shut down the machine.
2. Adjust the ionization probe and the electrode.
(See topic 7.4)
3. Check the burner orifice.
(See topic 7.5)
4. Set the air settings.
(See topic 7.6)
5. Adjust the head setting.
(See topic 7.7)
6. Check/set the supply gas pressure.
(See topic 7.8)
7. Start the machine and the burner.
8. Check/set the burner gas pressure.
(See topic 7.9)
This procedure continues on the next page.