Wacker Neuson DT10, Operator'S Manual

Page: 52 / 120

3-22
BA DT10 en - Edition 1.5 * * dt10b330.fm
Operation
Loading and transporting the machine
Safety instructions
• The transport vehicle must be of sufficient size. See Chapter 6 “Technical data” for
the dimensions and the weight of the machine!
• Remove any mud, snow or ice from the tracks so that the machine can be safely driven
onto the ramps
• Secure the machine against unintentional movement!
– see Parking the machine on page 3-19
Danger!
The machine must be loaded and transported properly –
Accident hazard!
☞
It is essential that you read the safety instructions at the beginning of this
chapter and follow any other safety instructions relevant in your country!
Load as follows:
☞
Secure the transportation vehicle with chocks to prevent it from rolling
☞ Place the access ramps at the smallest possible angle. Ensure that the grade does not
exceed 15° (26%). Use access ramps with an anti-skid surface only.
☞
Ensure that the loading area is clear and access to it is not obstructed – for example by
superstructures
☞ Ensure that the ramps and the tracks of the dumper are free of oil, grease and ice
☞
Start the engine of the dumper
☞ Lower tipping trailer
☞
Raise the loader unit enough so that it will not touch the access ramps
☞ Carefully drive the dumper onto the middle of the transport vehicle
☞
Lower the loader unit to the loading area
☞ Stop the engine
☞
Remove the starting key
Notice!
The manufacturer’s warranty shall not apply to accidents or damage caused by
loading or transporting.
<17°
Fig. 47: Access ramps
< 15°