Wacker Neuson DT10, Operator'S Manual

Page: 26 / 120

2-6
BA DT10 en - Edition 1.5 * * dt10b210.fm
Safety instructions
• The machine has no FOPS protection. Therefore, do not use the machine in areas with
danger of falling objects!
• Before leaving the operator seat always secure the machine against unintentional
movement and unauthorized use!
Lower the work equipment to the ground
• Before starting work check whether
• all safety devices are properly installed and functional
• Before starting machine travel or before taking up work:
• Ensure that visibility is sufficient
• Inspect the immediate area (children!)
• On the job site the operator is responsible for third parties!
• Extreme caution is essential when handling fuel – increased fire hazard!
• Ensure that fuel does not come into contact with hot parts!
Do not smoke during refueling, and avoid fire and sparks. Stop the engine during
refueling and do not smoke!
• Operation in potentially explosive areas is prohibited.
• Never get on or off a moving machine! Never jump off the machine!
• The drive levers take time getting used to them. Adjust the drive speed to your abilities
and the circumstances.
Applications with lifting gear
Definition:
Applications with lifting gear are understood as procedures involving raising, transporting
and lowering loads with the help of slings and load-securing devices (for example ropes,
chains). In doing so, the help of persons is necessary for securing and detaching the load.
This applies, for example, to lifting and lowering pipes, shaft rings or containers.
• No applications with lifting gear!
Trailer
• Hitching and towing other vehicles is prohibited!
Transportation
• The machine must be loaded and transported only in accordance with the Operator’s
Manual!
• Use only suitable means of transport of appropriate capacity/payload!
• Safely secure the machine on means of transport! Use suitable tie-down points and
load-securing devices
• The recommissioning procedure must be strictly in accordance with the Operator’s
Manual!
Temperature ranges
The machine can be operated at a maximum temperature of +45°C and a minimum tem-
perature of -15°C; If the machine is to be used in other temperature ranges (e.g. in tropical
temperatures etc.), you must contact the Wacker Neuson distributor.
Carry out all maintenance and inspection work before storing the machine for the winter.
Then store the machine in a dry place at ambient temperature (about +15 °C). Observe
these temperature ranges so as not to affect the machine’s service life.