42
MAINTENANCE
WHEEL REDUCERS
WHEEL REDUCERS
WHEEL REDUCERS
WHEEL REDUCERS
WHEEL REDUCERS
Every wheel is activated by a hydrostatic motor-reducer.
For oil checks, filling, replacement in the wheel reducers refer to that specified below.
Periodically check (see MAINTENANCE TABLE) that there are no leaks and that with the
machine at a standstill and the reducers positioned as indicated below, the oil reaches the
envisioned level; restore if necessary.
A top-up higher than 10% of the quantitative total could be a sign of leakage of the reducer.
The first oil change must be carried out after 100 hours of functioning. The
following changes after 1000 hours or at least once a year.
Per capacity and type, refer to the LUBRICANT TABLE.
The reducer must be emptied immediately after functioning, with the oil still hot to prevent impurities
from depositing.
- Pay particular attention during emptying as the hot oil could cause serious burns; protect
the hands.
- Clean the cap with liquid detergent especially during the filling phase. Cleanliness is an
important component for the good functioning of the machine and the hydrostatic plant in
particular.
FILLING
LEVEL
CONTROL
LEVEL
CONTROL
EMPTYING
