22
OPERATOR CONTROLS
-
Operator correctly positioned inside the driver’s
cabin for use of the machine both in the transfer
phase and for working.
MA
MA
MA
MA
MACHINE ST
CHINE ST
CHINE ST
CHINE ST
CHINE STAR
AR
AR
AR
ART
T
T
T
T-UP
-UP
-UP
-UP
-UP AND SHUTDO
AND SHUTDO
AND SHUTDO
AND SHUTDO
AND SHUTDOWN
WN
WN
WN
WN
STARTING
-
For proper starting follow the instructions de-
scribed above and as indicated below.
-
Once the engine has started, gradually move
the accelerator (Ref. LA) lever to the idle posi-
tion, at a sufficiently low rpm and avoiding sud-
den acceleration, until the hydraulic system has
reached the operating temperature
(5 ÷10 min-
utes depending on the atmospheric conditions
and climatic.
Start-up can only be carried out with
the safety bar raised, Position “A”
Do not allow unauthorised persons to drive the machine. Remember that the responsibility for the
machine lies with the person who has received it.
Do not start using the machine until sure of its functioning. It is a good rule to practice in an
open and clear area when manoeuvres in which experience is lacking need to be carried out.
Concerning driving of the machine follow the instructions as described below, remembering which
is the front side of the machine.
STOPPING
To stop the engine it suffices to turn the key
(Fig.1 - ref. 2) anticlockwise.
It is advisable to idle the engine for a few
minutes before stopping the machine.
Remove the key whenever leaving the driver’s seat.
Never leave the machine running and unattended.
POSITION A
POSITION B
2
