WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. November, 2019
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTIONS
Adjustable Beam Wall Wash
5222
STEP 3: DIMMING ADJUSTMENT
1. Use a Philips head screwdriver to adjust the dimming dial.
2. Rotate until the arrow on the dial is pointed at the desired wattage.
The wattage may be adjusted to the pre-existing tabs or any value
in between.
3. The lower the wattage, the dimmer the fixture will be.
4. Please refer to the yellow tag that is included in the packaging to
determine the size of the required transformer.
STEP 4: BEAM ANGLE ADJUSTMENT:
1. Note the three pre-determined beam angles on the beam angle
changing dial.
2. Use the provided Hex Key to slightly loosen the set screw one or
two turns. Do not remove set screw from the fixture.
CAUTION:
Do not remove set screw from the fixture.
It should only be removed from the fixture for servicing.
Consult factory for service instruction.
3. Hold the fixture body and rotate the dial until the arrow is aligned
with the desired beam angle. This beam angle may be one of the
pre-determined markings or any number in between.
CAUTION:
Keep the arrow marking on the fixture body between
the beam angle range.
4. Tighten the set screw until it stops. Do not over tighten.
Set Screw
Beam Changing Dial
Beam Angle Marking
Fixture Body
Rotation
NEMA
4X3
NEM
A
5X4
NE
MA
6X5
4x3
(60 H x 35 V)
5x4
(90 H x 60 V)
6x5
(120 H x 90 V)
STEP 5: VERTICAL FIXTURE HEAD ROTATION ADJUSTMENT
1. Note the fixture head can be rotated 90 degrees to achieve vertical
wall wash applications.
2. Hold fixture body with one hand and rotate the fixture head with
another hand to 90 degree.
3. Loose thumb screw and swap the horizontal shroud with a
vertical shroud.
NOTE:
Vertical shroud is not provided (sold separately).
Rotation
NEMA
4X3
NEM
A
5X4
NE
MA
6X5
5x6
(90 H x 120 V)
3x4
(35 H x 60 V)
4x5
(60 H x 90 V)
*8
*15
*22
*24
Model: 5222
*Numbers not printed
*3
