WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. November, 2019
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
STEP 1: DETERMINING THE LOCATION
1. Make sure your main power is off.
2. Excavate a trench for the UF supply line cable or
conduit/conductors and the Landscape Power Stake. The
Landscape Power Stake requires approximately a one (1)
square foot hole to facilitate installation. The excavated should
be approximately 15” deep. This will allow the hex-head set
screw on the Power Stake to remain above ground while the
installation is completed.
3. Turn the hex-head set screw counterclockwise to remove the
Power Stake Cap from the top of the PVC Light Stake.
4. Feed the light fixtures black, white, and ground wires through the
top of the Power Stake Cap. Then, thread the light fixture until it’s
firmly attached to the Power Stake Cap.
5. Fed the incoming supply line cable through the slanted bottom
of the PVC Light Stake.
NOTE
: If you are wiring multiple light fixtures in series, also bring
the second supply line cable into the PVC Light Stake.
6. Using appropriate UL Listed wire connectors, splice the white wire
from the light fixture to the incoming supply line cable(s) white
wire(s), and the black wire from the light fixture to the incoming
supply line’s black wire(s). Then splice the ground wire from the
light fixture to the incoming supply line cable(s) ground wire(s).
7. Place the Power Stake Cap with attached light fixture over the PVC
Light Stake. Carefully push the incoming supply line cable down
into the PVC Light Stake. Tighten the hex-head screw clockwise on
the Landscape Power Stake Cap.
8. Lower the completely wired and assembled Landscape
Power Stake into the excavated hole. Make sure that the
excavated hole is approximately 13” deep to allow the
hex-head set screw on the Landscape Power Stake Cap to
remain above the ground.
9. Back fill the soil around the Landscape Power Stake.
10. Repeat steps for other fixtures in the same electrical circuit.
11. Turn the main power supply back on and make sure the
fixtures light up.
INSTALLATION INSTRUCTIONS
Adjustable Beam Wall Wash
5222
Light Fixture
Power Stake Cap
PVC Stake
Incoming UF
supply line
cable of
conduit
Cap Locking Screws
1/2" NPT Threaded Hole
STEP 2: AIMING THE FIXTURE
1. Tilting: Loosen the joint screw and adjust the head of the fixture to
the desired direction before retightening the screw.
2. Loosen the mounting knob and rotate the fixture to the desired
position before retightening the knob.
Rotating
Joint Screw
Mounting Knob
Tilting
