Wabtec R-150, Installation Manual

Page: 54 / 106

G&B Specialties Inc. 535 West 3
rd
Street, Berwick, PA, USA Tel: 1-570-752-5901 Fax: (570) 752-639
1.0 I
NSPECTIONS
B
EFORE
O
PERATION
Prior to each use of the railgear equipment, the following items should be inspected:
 Check for damaged or worn parts
 Check for loose wheels and/or fasteners
 Check for leaking or damaged hydraulic lines, fittings, and cylinders
 Check for proper lubrication at specified intervals
Also, the operator should ensure that the vehicle is in good operating condition by
following the vehicle manufacturer’s operating guide.
WARNING:
Following the first eight (8) hours of rail travel, an initial wheel bearing
inspection and verification of sufficient wheel bearing grease should be
performed. During this time period, the wheel bearings will have seated
themselves and may require adjustment of endplay. If the endplay is not in
accordance with specifications, bearing failure could occur and would not be
covered under the Rafna Industries Warranty. Refer to the Rail Wheel
Bearing Adjustment procedure in the Service section of this manual.
On newly installed railgear equipment, ensure that the Railgear Alignment
procedure is performed before operation of the equipment. Note that
excessively worn rail wheels, vehicle pulling to one side while on rail, and
vibrations through the vehicle while on rail are indicators of mis-aligned
railgear. If any of these situations are encountered, proceed to perform the
Railgear Alignment procedure as described in the Service section of this
manual as soon as possible to avoid damage to the equipment, vehicle and/or
possible personal injury.