Wabtec R-150, Installation Manual

Page: 24 / 106

G&B Specialties Inc. 535 West 3 rd Street, Berwick, PA, USA Tel: 1-570-752-5901 Fax: (570) 752-639
1.0 S
TEERING
W
HEEL
L
OCK
I
NSTALLATION
This section covers the installation of the steering wheel lock. The hardware required for
this installation is listed in table 3-1.
Table 3-1: Steering Wheel Lock Installation Hardware
Part Number Description Qty
R-1623A Steering Wheel Lock Retainer 1
R-1623C Steering Wheel Lock 1
Steering Wheel Lock Decal 1
3

16
” Self-Tapping Screw x ¾” Long
4
¼” UNC Wing Nut 2
The following procedure details the steering wheel lock installation (refer to figure 3-1):
1.
Place the steering wheel lock (Item 1) onto the lock retainer (Item 2) as shown.
Fasten the steering wheel lock to the lock retainer using two ¼” wing nuts (Item 3).
2.
Position the steering wheel lock and lock retainer on top of the steering column cover
(Item 4). The hole in the lock retainer should fit over the hazard lights switch.
WARNING:
 Ensure that the air bag / horn cover in the steering wheel is not
obstructed by the installation of the steering wheel lock.
3.
Ensure the position will enable complete locking of the steering wheel (Item 5) while
not obstructing the air bag / horn cover. Mark the location of the lock retainer on the
steering column cover.
4.
Remove the steering column cover and fasten the lock retainer to the steering column
cover using four
3

16
” x ¾” long self-tapping screws (Item 6).
5.
Ensure that the screws will not interfere with components inside the steering column
and replace the steering column cover.
6.
Remove the steering wheel lock from the lock retainer by loosening the wing nuts.
Leave the wing nuts on the lock retainer and store the steering wheel lock in the cab.
7.
Locate and stick the steering wheel lock decal in a highly visible location on the dash.