Replace
Worn spray nozzle
The gun does not spray
Clean the paint from the engine
The pressure is set too low
The display was damaged or had a bad
connection
Thin or strain the paint following the manufacturer's
recommendations
Error code E03 is displayed
Replace the gasket
Too thick paint
Problem
painting
barrier
Suction pipe filter clogged
Clean or replace gun or filter
Incorrect submission
Loose suction pipe
Error code E02 is displayed
Allow to cool for 15 to 30 minutes
in case of poor connection or damage
The sprayer picks up paint, but it
drops when the gun is opened
Worn gasket
preventing
no display,
The paint is too heavy or thick
between the pressure sensor and the printed
circuit board (board with connections for mounting
electronic components)
Check the assembly
Replace the nozzle
Clogged filter
Check connection, replace display
Clear the filter
the unit is running
Worn or damaged service valve
Gun, tip, or suction filter is clogged. Clear the filter
Thermal overload tripped Motor overheated
Check the pressure sensor
Solution
Nozzle assembly leaks
Clean or replace the filter or replace the nozzle
seal. Keep extra filters handy
Rotate the nozzle
Device exposed to the sun
Worn nozzle
Check the signal line
Replace the valve
Clogged spray tip, gun filter, or tip
Move the device to a shady place
Replace the nozzle with a new one
on
Worn V-packing
Increase the pressure
Clean or replace items
Thin the paint if possible
Pressure sensor failure
Cause
Paint builds up on the engine
Clogged gun filter or tip gasket
Nozzle in cleaning position
Tighten the suction pipe fitting
Connection error
20
WABRO sc ul. Arki Boÿek 2A, 41-910 Bytom
NIP: PL6263032331 | Regon: 381911373
Wabrotech.pl
Machine Translated by Google
WABRO sc ul. Arki Bożka 2A, 41-910 Bytom
NIP: PL6263032331 | Regon: 381911373