1. SAFETY WARNINGS
2
• During work, use protective equipment: work clothes, non-slip shoes, protective glasses, dust mask and ear
protectors. Long hair should be tied up and hidden under a hat.
• The machine may be used by a person who has thoroughly read and understood the content of the Operator's Manual.
• Keep your hands away from the rotating spindle, do not remove the spoil with your hands or other objects.
• When putting the machine into operation, we must verify that previous users or service technicians left it in a
condition for safe start-up.
• Before commissioning, check that the supply voltage corresponds to the value stated on the nameplate.
• The machine should only be connected to the mains when working.
• It is forbidden to use diamond bits that do not correspond to the technical parameters given in the Operating
Manual.
they are conducted.
• We recommend that you use a drill bit with a maximum diameter of 100 mm when drilling by hand.
• Keep power tools out of the reach of children when not in use. Do not give the tool to use by persons who
are not familiar with it or have not read these regulations. Power tools used by inexperienced persons are
dangerous.
• Do not work with a dull or damaged drill bit.
• Carefully maintained cutting tools with sharp cutting edges clog less often and more easily
• No unauthorized persons are allowed in the workplace.
• Each time before starting work, check the technical condition of the tool. If damage, cracks, scratches or
deformations are detected, do not start the device - replace the tool with a defect-free one.
Keep cutting equipment sharp and clean.
• Keep your hands away from the drilling area. The cutting tool fitted to the machine has cutting edges and
rotates at a very high speed during operation, creating a risk of injury from concrete splinters.
• All guards responsible for safety must be maintained in full technical condition. If they are damaged, they
must be repaired or replaced immediately.
• Do not lift the machine by the power cord and do not pull the cord when removing the plug
• It is forbidden to leave the machine in the rain or use it in wet conditions.
precautions to prevent unintentional activation of the device.
energy, the machine cannot automatically continue the interrupted operation.
• During operation, do not overload the machine - use only the pressure necessary for proper functioning.
• Do not use the machine near containers with flammable liquids or gases.
from the socket.
• Pull the plug out of the socket before changing tools or putting the tool away. This measure
• In the event of a power failure, the machine must reach a safe state. After power on
Perform these operations after the machine has come to a complete stop and the power plug has been pulled out.
• Do not use tools contrary to their intended use.
WABRO sc ul. Arki Bozka 2A, ul. Arki Boÿek 2A
NIP: PL6263032331 | Regon: 381911373
Wabrotech.pl
Machine Translated by Google
