Page 9
SET UP & USE
PARTS & FEATURES
Temperature Control
(not shown bottom rear)
Freezer
Door
Leveling Legs
6. Remove the screw hole cover from the opposite side of the upper cabinet and
reinsert it to the same location to cover the screw hole openings of the just
removed screws.
7. Align the door with the cabinet first. Then re-install the bottom hinge to the
bottom opposite side of the cabinet. Insert the 3 screws into the holes. Tighten
the screws.
8. Remove the pin cap from the right side of the upper frame of the door, and
then reinsert it to the same location on the opposite side.
9. Align top hinge with screw holes, insert the 3 screws and partially secure.
Make sure the door and cabinet are properly aligned and then secure tightly.
10. Place the unit back in an upright position. Replace the top hinge cover.
STARTING YOUR NEW FREEZER
1. After cleaning your freezer thoroughly. Wipe the outside with a soft dry cloth, the
interior with a clean moist cloth.
2. Insert the power supply cord into the socket.
3. Turn the thermostat dial to an initial setting of “6” for 24 hours and then set the
freezer to your desired setting.
NOTE:
· As the door gets pressed in during shipping, the gasket may have to be reset. This is
done to prevent the cool refrigerated air from escaping. If there is a gap between the
door gasket and the cabinet, set the gasket by gently pulling it out of the seal gap.
1
2
3
4
5
6
Bottom
door hinge
Shelves
Ice cube tray
and ice scraper
