Page 7
SET UP & USE
INSTALLATION GUIDE
1. Unpack your freezer by removing all packaging materials like carton, base, foams,
adhesive tape, etc.
2. Remove all accessories, internal packaging material used to hold shelves, ice tray,
etc. in place.
3. Clean the remains of all adhesive tap used and remove all printed material
supplied.
4. Install the freezer in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the freezer and side wall so the door(s) will
open without obstruction. Freezer is not designed for recessed installation.
5. The floor on which the freezer should be placed must be flat, hard, solid, and
even. The freezer should not be placed on any soft material such as foam, plastic,
etc.
6. To level your freezer, use the two leveling legs located on the bottom front of
your freezer. Adjust by turning the legs counter clockwise to raise or clockwise
to lower your freezer. The door will close easier if the leveling legs are extended.
The following are recommended minimum clearances around the freezer for
proper air circulation:
Sides: 5” (127mm)
Top: 2” (50mm)
Back: 5” (127mm)
Proper air circulation will help your freezer work at maximum efficiency.
NOTE:
· The appliance must be correctly connected to the power supply.
WARNING
It is important to keep the power cord away from the compressor at the back of
the freezer as during operation, the compressor can reach a high temperature
and could cause serious damage to the power cord.
CAUTION
Care should be taken during the handling moving and use of the freezer to avoid
damaging the refrigerant tubing or increasing the risk of a leak
