4 Configuring the V290iA
22
V290iA User Guide
Configuring the Cisco Router
This section describes the Cisco default configuration, and an example of SCADA traffic
configuration.
V290iA Cisco 3200 Default Configuration
The V290iA Cisco 3200 component default configuration enables the following
operations:
Local Telnet connectivity to the UHF modem via the FESMIC LAN interfaces for
management and monitoring purpose.
Local Telnet connectivity to the WMIC card via the FESMIC LAN interfaces for
management purpose.
WiFi client’s connectivity.
Serial ports connectivity by Telnet tunneling. In this configuration, data can be
received or transmitted using Telnet to the router IP address with the relevant TCP
port.
The default configuration disables all the dynamic routing protocols and the Cisco
discovery protocol.
Default Configuration Parameters
MARC IP address via the RF (UHF) link is acquired by DHCP and is
192.168.100.10 when the UHF modem is not registered to the WMTS
MARC IP address via the FESMIC LAN interface is 10.0.0.30
WMIC IP address is 10.0.0.1
Default Configuration CLI Commands
The following displays the V290iA Cisco 3200 default values’ running configuration.
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
no service config
!
hostname Router
!
boot-start-marker
boot-end-marker
!
!
no aaa new-model
!
interface Serial1/3
physical-layer async
no ip address
!
interface FastEthernet2/0
!
interface FastEthernet2/1
!
interface FastEthernet2/2
!
interface FastEthernet2/3
!
interface Vlan1
