FCC Compliance Information
NOTE: This equipment is authorized under FCC ID PBJ290-IA to operate in the A block of the
Upper 700 MHz Guard Band pursuant to Part 27 of the FCC’s rules.
In addition, this equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the FCC’s rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generated, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment on and off, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the antenna.
Increase the distance between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver was connected.
Consult the dealer or an experienced radio/TV technician for assistance.
NOTE:
This equipment is authorized under FCC ID No. LDK102052P and complies with
15C.
User installation is prohibited. The antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter. End-users and installers must be
provided with antenna installation instructions and transmitter operating conditions for satisfying
RF exposure compliance.
Warning!
Changes or modifications to this equipment not expressly approved by Vyyo
Inc. could void the user’s authority to operate the equipment.
This product was tested with shielded coaxial cable (not provided by Vyyo) and
Category 5 Ethernet cable (optional) equipped with a shielded RJ-45 connector.
These types of cables must be used with the unit to ensure compliance.
