Vykon JACE-700, Install Manual

Page: 15 / 36

ABOUT EXPANSION OPTIONS May 2, 2011
About Option Cards
|
JACE-700 MOUNTING AND WIRING GUIDE Part Number 11694 Rev 1.6
15
About Option Cards
The JACE-700 controller has two (2) available option slots to accept a custom option
card, compatible with either of these types:
• JACE-2/6 compatible options cards: 30-pin, 2 row connector, or
• Future release JACE-7 option cards: 40-pin, 3 row connector.
To accept either, both option slots on the controller’s base board have a 40-pin
connector. See
Figure 5 on page 14. Installing an option card is recommended before
mounting the unit. See “Installing an Option Card,” page 16.
Warning
Power to the controller must be OFF when installing or removing
option cards, or damage will occur! Also, you must be very careful to
plug an option card into its connector properly (pins aligned).
Option cards typically provide additional communications features, with the
following available models (with others still in development) listed in
Table 2 .
Table 2 JACE-700 controller option cards.
Option Description Notes
NPB-2X-485 Dual, optically-isolated, RS-485
adapter with two 3-position remov-
able screw-terminal connector plugs. 30-pin option card.
If installed in option slot 1, ports operate
as COM5 and COM6.
NPB-LON FTT-10A LON (LonWorks) adapter
with a 2-position removable
screw-terminal connector plug. 30-pin option card.
Port operates as LON1 if only one LON
option, or LON2 in slot 2 if two LON cards.
NPB-232 Single port RS-232 adapter, with a
DB-9M connector. Supports baud
rates up to 115200. 30-pin option card.
If installed in option slot 1, port operates
as COM5.
NPB-GPRS-W GSM cellular modem card using
GPRS (General Packet Radio Ser-
vice), with onboard socket for SIM
card, and a Wyless SIM. Includes an
SMA antenna. 30-pin option card.
Card uses two JACE-700 COM ports, e.g.
COM5 and COM6 if option slot 1.
NPB-ZWAVE
-US
or
-EU
Z-Wave wireless serial gateway
between the JACE’s NiagaraAX sta-
tion and an RF wireless Z-Wave
domain. Includes RP-SMA antenna. 30-pin option card.
-US model is 908.42 MHz for U.S. usage
-EU model is 868.42 MHz for European
usage. If installed in option slot 1, card
operates as COM5.
NPB-SRAM Provides “battery-less” operation.
Card has static RAM (SRAM) and
integral backup capacitor for data
storage during power lost periods. 30-pin option card.
Does not use/affect COM port operaton.
NOTE: Use requires removing NiMH bat-
tery pack and any external 12V battery.
NPB-SED-001 Sedona Framework option card with
both wireless 6LoWPAN and wired
RS-485 port, based on the Jennic
JN5139 wireless microcontroller.
Includes RP-SMA antenna. 30-pin option card.
Enables JACE to operate as wireless net-
work coordinator and 6LoWPAN tunnel, to
integrate wireless Sedona-based devices
in the hosted station. Card uses one COM
port, e.g. COM5 if slot 1.
NOTE: COM port used is not available in
the hosted NiagaraAX station, but is
reserved for future MS/TP support.