37
PRESSURE WASHER 3600P
How to Replace the Spark Plug
Check the gap (A) with a wire gauge (B). If necessary, reset the gap. Install and
tighten the spark plug to the recommended torque. For gap setting or torque, see the
Specifications
section. Note: In some areas, local law requires using a resistor spark
plug to suppress ignition signals. If this engine was originally equipped with a resistor
spark plug, use the same type for replacement.
Inspect Muffler and Spark Arrester (if applicable)
!
WARNING
Running engines produce heat. Engine parts,
especially muffler, become extremely hot.
Severe thermal burns can occur on contact.
Combustible debris, such as leaves, grass,
brush, etc. can catch fire.
• Allow muffler, engine cylinder and fins to cool before touching.
• Remove accumulated debris from muffler area and cylinder area.
WARNING
Replacement parts must be the same and
installed in the same position as the original
parts or fire could result.
Summary of Contents for VF3600P
Page 13: ...13 PRESSURE WASHER 3600P Component identification...
Page 42: ...42...
Page 43: ...43 PRESSURE WASHER 3600P...
