VYKING FORCE VF3600P, Instruction Manual

Page: 14 / 44

14
Assembly
!
DANGER
Remove the spark plug lead/wire prior to
performing any work or assembly of this
pressure washer.
Install Handle (See fig 1 & 2)
• Install the wheel assembly into the frame sleeve on the side of the fuel tank. The wheel
spring button is aligned with the casing hole and pops out.
• Install upper frame (handle) onto the lower frame by sliding the handle over the two
upright tubes on the lower frame and pressing down firmly until the handle is seated
and the two detent pins snap in place.
Attaching the Spray Gun (See fig 3 & 4)
• Screw the spray wand and the trigger handle together until they are secure.
• Insert the inlet coupler of the spray hose into the threaded fitting on the high pressure
spray gun and thread the black nut on by turning clockwise until it is hand tight.