17
PRESSURE WASHER 3600P
to the work area it can be used as a chisel or scraper to remove dirt & debris such as
peeled paint or mildew.
Green Nozzle = 25°
Known as the wash tip it has a medium fan for multi-purpose application. It delivers
medium impact pressure and cleaning coverage.
White Nozzle = 40°
With the largest fan area it delivers relatively low pressure ideal for delicate surfaces.
Ideal for washing & rinsing large areas or washing vehicles.
Black Soap Nozzle
This tip is used for chemical / detergent application. It is the lowest pressure nozzle
creating the largest orifice.
Operation
Pre-operation check
For your safety, to ensure compliance with environmental regulations in Australia, and to
maximize the service life of your equipment, it is very important to take a few moments
before you operate the pressure washer to check its condition. Be sure to take care of
any problem you find, or have your servicing dealer correct it, before you operate the
engine.
The following pre-start-up inspection must be performed before the start of each work
session and after every four hours of use. If any fault is discovered, the pressure washer
must not be used until the fault is rectified.
1. Thoroughly inspect the pressure washer for signs of damage. Check components are
present and secure.
2. Check for damage, kinks or twists in all lines and hoses before each use. Replace
any damaged hoses.
3. Check the ENGINE oil level and top up if necessary.
4. Check the FUEL level and top up if necessary.
5. Check for fuel and oil leaks.
6. Check the pressure washer is connected to an appropriate water supply - minimum
flow 15lt/min 20psi.
7. Check & tighten all connections.
Summary of Contents for VF3600P
Page 13: ...13 PRESSURE WASHER 3600P Component identification...
Page 42: ...42...
Page 43: ...43 PRESSURE WASHER 3600P...
