Air Jacketed CO2 Incubator
1-3
VWR International
Section 1
Installation and Start-Up
The VWR Air Jacketed Incubator has four basic modes for incubator
setup: Run, Setpoints, Calibration and Configuration.
• Run is the default mode for normal operation.
• Set is used to enter system setpoints for incubator operation.
• Calibration is used to calibrate various system parameters.
• Configuration allows for custom setup of various options.
Table 1-1.
Selections Under Each Mode
Scroll Keys:
Steps the operator through parameters of SET, CAL and
CON modes. The right arrow goes to the next parameter, the left arrow
returns to the previous parameter.
Up/Down Keys:
Increases/decreases or toggles the parameter value select-
ed in SET, CAL, and CON modes.
ENTER:
Must press this key to save-to-memory all changed values.
Keypad Operation
RUN
SETPOINT
CALIBRATION
CONFIGURATION
Default Mode
Temperature
Temp Offset
Audible
Overtemp
CO
2
Cal
1
New HEPA Timer
CO
2
IR Cal
2
Replace HEPA Reminder
Access Code
Temp Lo Alarm
Temp Relay
CO
2
Lo Alarm
CO
2
Hi Alarm
CO
2
Relay
CO
2
Z & S #'s *
Display Temp
Display RH
1
T/C units
Base Unit Displays
2
IR units
Option Unit Displays
*T/C units only
