Vulcan-Hart 176-6799, Instruction Manual

Page: 12 / 51

1
8. Follow all instructions for the use of the air tool.
9. As air is used by the tool, the compressor will start up automatically to replenish the
pressure in the tanks and stop when full. It will continue to cycle as you work.
WARNING
!
The compressor motor and pump can get quite hot in operation. Do not touch
or allow others near the unit during or after operation.
10. When finished, disconnect the air hose by pushing the quick-connect plug in slightly while
sliding the sleeve on the coupler back to release the plug.
11. Push in the On/Off switch to stop the compressor.
12. Open the moisture release petcock (
M, fig.1 ) and allow all the air to escape from the
tanks.
WARNING
!
Wear safety goggles when opening the petcock. The escaping air can raise
debris particles which can damage your eyes.
l
After 2 weeks, tighten all nuts and bolts, including head bolts.
MAINTENANCE
WARNING
!
Before any maintenance or adjustments to your air compressor, always take
the following safety precautions:
1. Disconnect electrical power.
2. Open the petcock to drain air tank of pressure.
DAILY MAINTENANCE
Before each use:
l
Check the oil level
l
Be sure all nuts and bolts are tight
l
Check for any unusual noise or vibration
l
After use: open the air tank drain cock to drain condensation from tank. This is especially
critical in cold conditions when condensation could freeze in the tank and cause
mechanical damage as well as rust.
MONTHLY MAINTENANCE
l
Inspect air system for leaks by applying soapy water to all joints.
l
Tighten those joints if leakage is observed.
l
Check that all nuts and bolts stay tight.
250 HOURS or 6 MONTHS (whichever comes first): OIL CHANGE
l
After 250 hours of use, your compressor will require an oil change.
l
Paint spraying operations or dusty environments may require you replace oil more often
WARNING
!
Before any removing the oil drain plug (oil level sight glass) or the oil breather
cap from your air compressor, always take the following safety precautions:
l
Disconnect electrical power.
l
Open the petcock to drain air tank of pressure.