Vulcan-Hart 176-6799, Instruction Manual

Page: 9 / 51

9
8. Gently screw the oil breather cap into the oil fill hole. Do not cross-thread or overtighten.
NOTE
Before installing and using this unit, inspect carefully for damage and corrosion. Make
sure the tank, compressor, motor and pump are undamaged and that all screws and caps
are securely tightened.
INSTALLATION AND LOCATION
Locate the compressor in a clean, dry and well-ventilated area; on a firm, level surface. It
should be located 12 to 18 inches from a wall or any other obstruction that would interfere with
the air flow. It is equiped with heat dissipation fins that allow for proper cooling. Keep them and
other parts free of dust or dirt that could interfere with cooling. A clean compressor runs cooler
and provides longer service. Do not place anything on top of the compressor.
WARNING
! Do not use lead-tin solder to join pipes and fittings. It can melt at the
temperatures of the compressor’s air discharge and cause the piping to burst.
ELECTRICAL REQUIREMENTS
l
Check the specification label and be sure the
compressor’s voltage and amperage requirements
match the electrical supply capabilities.
l
Plug your compressor into an electrical outlet on
dedicated 15 amp household circuit. The closer the
outlet is to the circuit panel, the more reliable the
compressor starting and performance will be. Other
devices running on the same circuit may cause
starting problems.
l
Slow starting may cause the compressor’s internal
overload protection to trip. Press the compressor’s
reset button ( W, fig.2 & 5 ) to allow it to restart.
l
Ideally, the electrical supply circuit should be protected
by a circuit breaker rather than a fuse. If a fuse is
necessary, a dual element time delay fuse should be
used.
EXTENSION CORDS
If you plan to use an extension cord when operating your
air compressor, please note:
l
Maximum length: not to exceed 50 ft.
l
Minimum wire size: 14 gauge.
l
If the extension cord is too long or the wire size is too
small, the air compressor will not start.
COMPRESSOR LUBRICATION
1. CHECK THE OIL quantity and quality every time before operating the compressor. Do
not add or change oil while the compressor is in operation. Use only oil with the correct
specifications