22
9 – PUTTING EQUIPMENT INTO OPERATION
9.1. UNIVERSAL BLOCK’S START-UP AND OPERATION
INITIAL START-UP
Check up again all pipes connections (see section
“Universal filtration block mounting”). Finish swimming
pool water filling. Make sure, that the water level in the
swimming pool coincides with upper edge of the
skimmer shutter.
ATTENTION!
To keep water level in the swimming
pool on the same level with upper edge of skimmer
shutter, it is necessary to adjust the screw of water
filling device after swimming pool filling up with water.
For this purpose it is necessary to unscrew two screws
inside a filtration compartment of the block (see
drawing N*1), carefully remove the console. Adjust
water topping-up with the help of an adjustable screw
(see drawing N*2) so that water supply will be stopped
at reaching the level of upper edge of skimmer shutter.
After adjustment mount the console back on place and
fix it with screws.
The connected automatic water filling
system ensures reliable work of the filtration unit.
Draw. 1
Following the instructions from chapter «General safety rules»,
make electric connections. To remove air from the pipelines and
pump, take flexible hose, connect it to water pipeline and insert
into discharge nozzle, impacting the place of its inserting into
nozzle by hand or by anything available. Holding hose by hand,
open water supply and fill until the air bubbles will stop coming
out in the filtration compartment of filtration unit. Make sure
that there is no leakage in the pipes connection points. Backfill a
place around technical compartment and pipelines with sand!
Insert filtration membranes (see section «Filtration membrane
and its installation»). Switch on filtration unit, setting the
filtration mode switch of the electrical control panel in position
«manual».
After two-three days of filtration unit operation in a «manual»
Draw. 2
mode, set on the timer duration of water filtration cycles and set
the electrical control panel filtration switch in position «automatic
mode».
TIMER SETTING IN THE ELECTRICAL CONTROL PANEL
You can use the timer in your electrical control panel to set the times for the daily filtration of your pool.
REMEMBER!
The more often a swimming pool is filtrated, the cheaper is to maintain it!
Adapt the filtration time to water temperature: filtration time = temperature of water divided by 2 (for example,
water at t= 24°
С
, time = 24:2=12 hours (time which filtration unit must work)).
To set filtration time, it is necessary carefully with the help of small screw-driver to shift out the segments of the
timer outside. One segment corresponds to 30 minutes. To set timer’s clock, it is necessary to rotate clockwise a dial
face until a set time will not appear in the small window opposite a pointer.
It is forbidden to rotate a dial face
counter-clockwise
, it can damage it.
COUNTER-SWIMMING FUNCTION
Counter-swimming is switching on by pressing the pneumatic button of the filtration unit’s console (only in models
with the two-speed pump).
ATTENTION!
Do not leave a filtration unit in a counter-swimming mode for a long time as this function is not
intended for a continuous work.
adjustable screw
float
connection thread 3/8"
3. Take out console
1.Remove cover of filtration compartment
2.Unscrew 2 screws