PWM SERIES - User Manual
Page
VSi-PWM-2018-06
8
http://www.VSi.
UK
.com
3. Safety Instructions
Read and follow all Safety Instructions
Please save these instructions for future reference
3.1 Introduction
These instructions are addressed to the installer and End User / Operator
of the
PWM SERIES
of Single Phase Static Digital AC Voltage Stabilisers. We
strongly suggest you keep this manual next to the equipment for future
reference.
3.2 General Installation & Usage
Do not use the Stabiliser for other than the intended use.
Do not install Stabiliser in back feed circuits, such as solar panel and wind
turbine applications, where the energy is supplied back to the grid, nor
should the input voltage supply be connected to the output of stabiliser.
If on delivery there is evidence of visible damage, do not attempt to install
or start the Stabiliser. Advise the transport delivery company and inform
VSi, or the resale partner from whom you purchased the equipment.
The Stabiliser can contain potentially dangerous voltages – up to 300V AC.
As there are no user replaceable components, once installed there should
be no reason to remove the protective covers. If the covers are removed,
use extreme caution and do not leave the unit unattended with the covers
off.
Hazardous voltages can be present at the unit’s output any time AC input
power is applied. To avoid possible personal injury, or equipment
damage, and to make certain there is no output voltage, turn the unit off
and disconnect the AC Input.
To reduce the risk of fire, or electrical shock, install the unit in an indoor
area free from conductive contaminants.
