PWM SERIES - User Manual
Page
VSi-PWM-2018-06
21
http://www.VSi.
UK
.com
5.5 Normal Operation
5.5.1 Power Up
Without any connected load.
1.
Switch
CB 1
(Input Breaker) to the ‘ON’ position. Buzzer will
sound for approximately 2.5 seconds while the system runs
through a self-diagnostic testing routine.
Initially the ‘
LINE
’ Status Indicator on the Front Panel will
illuminate. When the self-diagnostic testing routine has
satisfactorily completed the ‘
INV
’ Status Indicator will light up.
2.
Switch
CB 2
(Output Breaker) to the ‘
ON
’ position.
3.
Press the ‘
ON
’ Button next to the Front Display for 2 seconds.
Front Display will activate.
Stabiliser should now be operational, able to support / have load
connected.
It is recommended that you check the output voltage with a True RMS
Voltmeter to ensure that the correct output voltage is displayed.
If the correct voltage is not measured by the multi-meter please advise
the resale partner / dealer you purchased the stabiliser from, or your
nearest VSi office. Please ensure you advise your support teams of the
model, serial number and where you purchased the stabiliser from.
5.5.2 Power Down
Switch off any connected load.
1.
Switch CB 2 (Output Breaker) to the ‘OFF’ position.
2.
Press the ‘OFF’ Button next to the Front Display for 2 seconds.
Front Display will deactivate.
While it may appear the stabiliser is fully powered down do not
attempt to remove any side panels from the stabiliser as internally
power will still be present until you complete the next step below.
