PWM SERIES - User Manual
Page
VSi-PWM-2018-06
18
http://www.VSi.
UK
.com
5. Installation & Operation Instructions
5.1 Unpacking & inspection
If on delivery there is evidence of visible damage, do not attempt to
install or start the Stabiliser. Advise the transport delivery company and
inform VSi, or the resale partner from whom you purchased the
equipment.
After unpacking and removing the polystyrene protective packaging
from the
PWM SERIES
unit, inspect the ventilation slots to ensure that
they are free from all obstruction. Use a vacuum cleaner to dislodge any
obstructions.
We would suggest you retain the packing carton and packaging material
to return the
PWM SERIES
Stabiliser in the unlikely event of its
operational failure.
5.2 Positioning
Although the Stabiliser does not produce excessive heat, you should
ensure that it is positioned so that a free flow of air allows the unit to
cool. To reduce the risk of overheating, do not block the unit’s ventilation
panels and try to avoid positioning the unit in direct strong sunlight or
close to other heat sources.
The Stabiliser is intended for indoor use only. Do not install inside a
closed cupboard and do not allow papers, or other materials, to be piled
on top of the enclosure.
Do not place the unit near water or liquids, gas and combustible
materials or in an excessively humid environment where condensation
is very likely to occur.
