VTAC USER MANUAL
VPC
10/10/2022
For more information visit vpc.com
14
9.
The tool is now loaded and ready to be transferred to a press. The tool
should be held together firmly and can be pressed with either side up.
10. Using a press, gently push the base and top of tool together until the contacts
are seated. Be careful not to over-press.
Figure F.
POSITION
BOARD
Figure G.
ALIGNMENT
PINS
CONTACTS
Figure H.
Join both halves of tool.
Figure I.
Check alignment of contacts and alignment pins with holes.
CHECK
ALIGNMENT
ALIGNING PCB AND USING PRESS
6.
Position the board so that the contacts and alignment pins are aligned with
the proper holes (
Figure F
)
.
7. Place the PCB onto the contacts and hold the board in position (
Figure G
)
.
8.
Place the other half of the tool on top. Hold the two halves together with
the board in between. Ensure the contacts and the alignment pins are in the
correct holes (
Figure H and I
)
.
USING VTAC RIGHT ANGLE HEADER INSTALLATION TOOL (cont'd)
PART # 910 112 132 , 610 151 104
