VTAC USER MANUAL
VPC
10/10/2022
For more information visit vpc.com
13
Figure A.
Install starting in the center.
CENTER POSITION
LOCATING HOLES
Figure B.
Install with front (contact surface) flush with tool edge.
FLUSH
FRONT
TOP
SURFACE
Figure C.
Top surface of insert(s) must sit flush with tool surface.
FLUSH
Figure D.
Back end of insert(s) should sit flush with tool edge.
FLUSH
PUSH
Figure E.
TAB
The VTAC Right Angle Header is installed via press fitting, using VPC's
special installation tool. For a brief video version of these instructions,
please
to access a video tutorial on VPC's YouTube channel.
INSTALLATION
1.
Load the desired number of header(s) into the tool. Header(s) should
be loaded starting from the center of the tool and evenly distributed
outward. The center position is marked by location holes (
Figure A
).
2.
Align the front of each header with the edge of the tool (
Figure B
).
3.
Position so that the top surface of each header is flush with the inner
surface of the tool (
Figure C
).
USING VTAC RIGHT ANGLE HEADER INSTALLATION TOOL
PART # 910 112 132 , 610 151 104
