9050 USER MANUAL
VPC
07/19/2022
For more information visit vpc.com
3
INSTALLING 9050 WITH VERTICAL HINGED MOUNTING FRAME
PART # 310 113 613, 310 104 368
TOOLS REQUIRED
Phillips Head Screwdriver
³/
32
Allen Wrench
NOTE:
Due to the weight of the VHMF (approx 15 lbs.) versus the receiver
(approx. 3 lbs.), it is recommended that the VHMF is attached to the test rack
first, followed by the receiver to the VHMF.
INSTALLATION
1.
Determine an appropriate location on the rack to mount the VHMF and
receiver. Keep in mind that the cables connecting to the receiver need to
be long enough to allow the VHMF to hinge down.
2.
Attach the VHMF to the rack in the desired location using the (8) 10-32 x 1”
mounting screws (
Figure A
). Tighten screws in a cross pattern to ensure
even torque is applied.
3.
Using the 6 receiver mounting holes on the front of the Vertical Hinged
Mounting Frame (VHMF), attach the receiver with the 10-32 x 1” captive
screws, lock washers, and hex nuts included with the Receiver (
Figure B
).
4.
When not in use, ensure that the receiver handle is closed (upward
position), and that the VHMF is in the closed position, secured with the
two screw knobs located at the top (
Figure C
).
Figure B.
Receiver attached to VHMF using captive hardware x 6 provided
with receiver.
SECURED
RECEIVER
MOUNTING
HARDWARE X 3
EACH SIDE
Figure A.
Back of VHMF with rack mounting screw holes x 8 highlighted.
Image also available in product drawing for p/n 310104368.
Figure C. VHMF and receiver installed on rack and not in
use.
SCREW KNOBS SECURED
RECEIVER HANDLE IN CLOSED
POSITION