Load the filament
12
For better printing, the end of filament
recommended as showed in the figure.
1. When waiting for preheating, please hang the
filaments on the material rack.
2. Select [Control]-[Automatic Load], operate it by according the instruction on screen. Pull the
filament to the feeding inlet on the extruder, and press the feeding handle, insert the filament into
the extruder vertically until feel a slight resistance.
3. Wait for the extruder to heated up to the target temperature and loading starts. When the
filament is extruded from the nozzle evenly, the loading is completed (When the printer has been
preheated, it is suggested to insert the filament directly without pressing the feeding handle).
Insert the filament into this position
45°
21
装料
为使耗材能顺利进入喷头，请将耗材末端斜剪至约
45°角（如图所示）。
1. 在等待温度上升时，将耗材挂在料架上。
2. 在显示屏上选择【控制】-【自动进丝】，按照屏幕指示操作。手动将耗材拉至喷头上方进丝口，按压进丝
把手，将耗材垂直插入喷头直至感受到轻微阻力即可。
3. 等待喷头自动加热至目标温度。当耗材开始均匀从喷嘴挤出时，进丝步骤完成（若设备已预热，可直接将耗
材插入进丝口，无需按压送丝把手）。
将耗材从该位置穿过