Wire connection
9
1. Connect the yellow-labled cable with "X" on 6 pin (4wires) port to X-axis motor.
将6针（4线）端口上带有黄色标签丝印“X”的线与X轴电机连接。
2. Connect the yellow-labeled cable with "X" on 3 pin (2wires) port to X-axis limit sensor.
将3针（2线）端口上带有黄色标签丝印“X”的线与X轴限位传感器连接。
3. Connect the yellow-labeled cable with "Z" on 3 pin port to Z-axis limit sensor.
将3针端口上带有黄色标签丝印“Z”的线与Z轴限位传感器连接。
4. Connect the yellow-labeled cable with "Z" on 6 pin port to Z-axis motor.
将6针端口上带有黄色标签丝印“Z”的线与Z轴电机连接。
5. Plug in the power cord (as showed) and toggle the switch to turn on the power.
插入电源线(如图所示)并拨动开关以打开电源。
X、Z-axis motor port
X、Z-axis limit sensor
Power cable *1
X-axis motor
X-axis limit sensor
Z-axis limit sensor
Z-axis motor
16
2
1
3
4
5
X、Z轴电机接口
X、Z轴限位传感器接口
电源线 *1
X轴电机
X轴限位传感器
Z轴限位传感器
Z轴电机
！
Attention
· Damage might occur if voltage is
set incorrectly. Make sure the
current input voltage matches to
your local mains
(115/230 V).
· Plug in power cord and turn
power switch to 1 to turn it on.
· Do not disconnect the cables
when the printer is powered on.
注意
· 如果电压设置不正确，可能会造成
损坏。选择正确的输入电压以匹配您
的本地电源
（115/230V）
。
· 连接电源线并将电源开关拔至I档即
可开机。
· 当机器通电时，请勿断开连接线。
设备接线