Vortice VORT HRW 30 MONO EVO WiFi, Instruction Booklet

Page: 42 / 132

42
• “Low battery indication” function
When the remote control has been used for a long time and there is no enough power left, the remote control will show
“low battery indication” on the LCD , it shows the user need to replace a new battery. It will blink all the time till the
battery has been replaced.
• “Backlight” function
When using the remote control, the LEDs backlight is on. If the remote control has not been used for 10 seconds, the
backlight function is turned off for energy saving.
• “ Reset” function
A small hole in the back of the remote control works as reset function.
Maintanance and cleaning
Before starting any maintenance or cleaning operation set the device to standby mode (LEDs in SPEED column turn off)
and wait for the fan to stop.
Filters cleaning
The maintenance time for filters can be set to 90, 180 or 365 days (see specific section in the "programming sequence").
Cleaning /replacement of internal filter (fig. 31): Remove the closing disk (1), remove the filter (2), wash or replace it
and reposition it in its seat with the filter frame; re-insert the closing disk.
Cleaning /replacement of external filter for HRW 40 MONO EVO (fig. 32) model: follow the steps from 1 to 5 and repeat
them in the reverse order once the filter has been cleaned or removed.
Cleaning/ replacement of external filter for HRW 30 MONO EVO (fig. 33) model: follow the steps from 1 to 4 and
repeat them in the reverse order once the filter has been cleaned or removed.
On every model it is mandatory to reset the saturated filter situation by following the procedure described in the section
“parameters programming sequence”, before returning to the normal functioning of the device.
N.B. Failure to clean or replace filters causes problems for system efficiency, including:
• Increase in pressure losses in the air circuit and reduction of air flow;
• Consequent decrease in machine yield and worsening of comfort in the environment.
ENGLISH
31 31
1
2