52
I RECEIVING THE EQUIPMENT
Systems are supplied fixed to guides or plates and wrapped in plastic film.
I.1 Checks on receipt
On receipt of the equipment, carefully inspect the packaging and the contents. If damaged, record an accurate
description of the damage on the delivery note.
I.2 Unpacking
When unpacking the equipment, check the following :
- The total number of packages is present.
- All the accessories (dampers, covers, electrical equipment. etc.) ordered are present.
After unpacking the equipment, all packaging materials should be disposed of in accordance with the applicable
regulations.
Dispose of waste materials responsibly.
I.3 Storage
The equipment must be stored in a dry enclosed area, at a temperature between -20 and 40°C; note that the packaging
does not offer sufficient protection against bad weather.
II INSTALLATION
II.1 Handling
The units must only be moved to their installation position.
If the equipment is handled using a fork-lift truck, ensure the forks support the load-bearing structure. Check that the load
capacity of the handling equipment used is suitable for the weight of the equipment received (refer to the weight data in
the manual).
If the equipment is handled using a crane, use 4 lifting ropes of the length indicated. The ropes must be at least as long
as the greatest distance between two attachment points.
If the width + height > 5 metres
_
the packing crate must lifted using a sling bar.
SAFETY INSTRUCTIONS
In compliance with the current standards, the machine should be installed only by technical personnel who are
qualified to work on equipment of this type.
Use the required personal protection equipment to avoid risk of injury from electrical, mechanical (injury from contact
with steel sheets, sharp edges, etc.) eye protection (UVC hazard; wear goggles to EN170) or noise hazards.
Do not use this equipment for any purpose other than that for which it is designed. This machine may be used
exclusively for the distribution of air that is free of hazardous substances.
The machine should be handled in accordance with the indications given in the relative section of this manual.
The machine must be connected to earth in accordance with the applicable regulations. Never start a unit that has
not been connected to earth.
Before carrying out any work on a unit, make sure that its is switched off and before opening panels or doors, wait
until all the moving parts have come to a stop (damper, fan and rotary heat exchanger).
During operation, all panels, inspection hatched and doors must always be fitted and closed.
The unit must only be started or stopped using the proximity switch.
Safety and control devices must not be removed, by-passed or deactivated.
When working on the unit, be aware that certain components can reach high temperatures (water coil or electric
heater).
The system must be installed in accordance with fire prevention regulations.
All waste materials must be disposed of in accordance with the applicable regulations.
The manufacturer accepts no liability for damages ensuing from the incorrect use of the equipment, unauthorized
repair or modification, or failure to follow the instructions given in this manual.
ENGLISH
