11
6
(continued)
6a
Adjust device for top latch retraction position.
Turn
top lift finger screw
counterclockwise an
additional 2 full turns.
Put top latch in
locked position.
While pressing down on
top lift finger
screw
(a-7) so it is seated, tighten
top
locking screw
(a-8).
a-1
a-2
a-7
a-8
a-4
a-3
a-5
a-6
With pushpad depressed, you should be
able to release top latch with your finger,
as shown below.
Using your finger, put top
latch in locked position.
a-9
a-10
If using 360L / 360T trim, turn and hold
lever / thumb turn instead.
!
2 additional
turns
Maintain downward pressure on screwdriver
and turn
top lift finger screw
counterclock-
wise to lower lift finger. With other hand,
press on top latchbolt. STOP as soon as top
latch releases.
Locked
Released
Steps marked with a symbol are different if using 360L / 360T trim.
If top latch releases,
adjustment is good;
proceed to Step a-5.
Otherwise, continue to
Step a-3.
Depress and
HOLD
push pad (or dog device)
until Step a-6.
If using 360L / 360T trim,
release lever / thumb turn
instead.
Release push pad.
6b
Adjust device for bottom latch retraction positon.
For 2-Point Latch Only
Push up on
bottom lift finger screw
so it is seated, and tighten the
bottom
locking screw.
Depress and
HOLD
push pad (or dog
device) until Step b-4.
Maintain upward pressure on screwdriver and
turn
bottom lift finger screw
(b-2) counter-
clockwise to adjust past point where
bottom lift
finger
contacts
bottom spool input
(b-3).
Continue adjusting until
bottom spool input
reaches end of travel or until
bottom lift finger
reaches max adjust.
max adjust
0
b-1
b-2
b-4
b-5
b-6
b-3
If using 360L / 360T trim,
release lever / thumb turn
instead.
Release push pad.
If using
360L / 360T trim,
turn and hold
lever / thumb turn
instead.
