8
5
DEVICE INSTALLATION
5a
If necessary, cut device.
Door
1
¹⁄₂
" (38 mm)
Recommended
Jamb
Jamb
Cover Plate
Flush
Temporarily Remove
Anti-Rattle Clip
5b
Install lift fi nger(s) and retainer clip(s).
Lightly tighten
locking screw
(b-7).
Install retainer clip against lift finger,
snapping it into the slot of the
lift
finger screw
.
For 2-Point Latch Only
Confirm
lift finger screw
is
free to rotate (b-8).
!
Slide L-shaped lift finger thru upper
block on front of center case.
Insert
lift finger screw
and turn
clockwise with screwdriver to raise
lift finger until the slot
aligns with diameter
of screw hole.
Repeat steps b-1 thru
b-8 for lower block of
center case.
It may be necessary to rotate
the
lift finger screw
to realign
retainer clip and lift finger holes.
!
(1
³⁄₄
" door)
(2
¹⁄₄
" door)
Bottom
Top
b-2
b-3
b-5
b-6
b-7
b-4
b-9
slot
b-8
Using tube of grease provided, apply grease to interior of rod connector
sleeve in locations shown (b-1). With device center case hanging over edge
of table, slide rod connector sleeve over top end of center case in
orientation shown (b-2), then insert mounting screw thru hole in center case
and slot in clip (b-3).
Block may need to
be pushed down
to insert screw
b-1
