Volvo XC90 T8 TwinEngine Plug-In Hybrid, Owner'S Manual

Page: 100 / 534

INSTRUMENTS AND CONTROLS
* Option/accessory, for more information, see Introduction. 98
Programming the HomeLink
®
Wireless Control System
*
NOTE
Some vehicles may require the ignition to be
switched on or be in the “accessories” posi-
tion for programming and/or operation of
HomeLink. It is also recommended that a new
battery be placed in the hand-held transmitter
of the device being programmed to Home-
Link for quicker training and accurate trans-
mission of the radio-frequency signal. The
HomeLink buttons must be reset first. When
this has been completed, Homelink is in
learning mode so that you can perform pro-
gramming.
To program HomeLink
®
1. Press the HomeLink
®
button to be pro-
grammed. The HomeLink
®
indicator will
begin flashing yellow once a second. You do
not need to continue holding the button.
2. Point the hand-held transmitter toward the
HomeLink
®
button to be programmed and
hold it approx. 6–12 inches (15–30 cm)
away from the HomeLink
®
button. Do not
obstruct the HomeLink
®
indicator light.
3. Press and hold the button on the original
remote control that is to be programmed on
HomeLink
®
and observe the HomeLink
®
indicator light. Hold the button until the indi-
cator light has changed from flashing yellow
once a second to either flashing green 10
times a second or by glowing steadily green.
When the HomeLink
®
indicator light flashes
or glows steadily green, the button on the
original remote control can be released.
Note
: for certain remote controls, the
instructions listed under "Gate operators/
Canadian programming" at the end of this
article should be used instead of step 3.
4. Press the programmed HomeLink ®
button
and check the indicator light.
Indicator light glows steadily green:
pro-
gramming has been completed. The garage
door, gate, etc., should now be activated
when the programmed button is pressed.
Indicator light flashes 10 times a second:
press the HomeLink
®
button that is being
programmed. Hold it for 2 seconds and
release it. Repeat the “press/hold/release”
sequence a second time, and, depending on
the brand of the garage door opener, repeat
this sequence a third time to complete the
programming process. Programming should
now be completed and the garage door,
gate, etc., should now be activated when the
programmed button is pressed.
If the garage door, etc. still does not
react:
continue with steps 6-8 to complete
programming.