Volvo S60 Twin Engine 2020, Owner'S Manual

Page: 470 / 687

STARTING AND DRIVING
* Option/accessory. 468
Calibrating the compass
*
The globe is divided into 15 magnetic zones.
The compass
27 should be calibrated if the
vehicle is driven from one zone to another.
1. Stop the vehicle in a large, open area away
from steel constructions and high-voltage
power lines.
2. Start the engine and switch off all electri-
cal equipment (climate system, wipers,
etc.) and make sure all doors are closed.
NOTE
Calibration may fail or not even be initiated
if electrical equipment is not turned off.
3. Hold the button on the bottom of the rear-
view mirror pressed for about 3 seconds
(using e.g. a paper clip). The number of the
current magnetic zone is shown.
15
14
13
12
11
9
8
7
6
5
4
3
2
1
10
Magnetic zones.
4. Press the button on the underside of the
mirror repeatedly until the desired mag-
netic zone (
1–15 ) appears (see the map of
magnetic zones).
5. Wait until the display again shows C , or
press and hold the button on the under-
side of the rearview mirror for approx.
6 seconds until
C is displayed.
6. Drive slowly in a circle at a speed of no
more than 10 km/h (6 mph) until a com-
pass direction is shown in the display. This
indicates that calibration is complete.
Drive in a circle two more times to fine-
tune the calibration.
7. Vehicles with heated windshields
*
: If C
is shown in the display when the wind-
shield heating function is activated, per-
form step 6 above with the heating func-
tion on.
8. Repeat the above procedure as needed.
Related information
•
Compass
*
(p. 467)
•
Activating and deactivating the compass
*
(p. 467)
27 Rearview mirror with compass is available as an option only on certain markets and models.