Volvo S40 - ANNEXE 244, Owner'S Manual

Page: 267 / 316

10 Infotainment system
Phone functions*
10
``
*
Option/accessory, for more information, see Introduction.
267
On/Off
A handset appears in the display when the
phone system is active or in standby mode
(standby). If the remote control key is turned to
position
0 when the phone is in one of these
modes, the phone automatically resumes this
mode the next time the remote control key is
turned to position
I or II .
Activating the phone system
Phone system functions can only be used
when the phone is in active mode.
1. Press PHONE .
2. Enter the PIN code (if necessary) and press
ENTER .
Deactivating the phone system
No calls can be received when the phone sys-
tem is deactivated.
Hold PHONE depressed until the phone is
deactivated.
Standby mode (standby)
In standby mode, the audio system can be in
use while calls are received. However, it is not
possible to make calls when in standby mode.
Putting the phone in standby mode
The phone must first be in active mode before
it can be put in standby mode.
Press PHONE .
Activating from standby mode
Press PHONE .
Making and receiving calls
To call
1. Activate the phone system (if necessary).
2. Dial the number or use the phone book,
see page 269.
3. Press ENTER .
Receiving a call
For Auto answer, see menu option 4.3, see
page 271.
Press ENTER .
Ending a call
Press EXIT .
Refusing a call
Press EXIT .
Call waiting
A two-tone signal during a phone call indicates
that there is another incoming call.
Answer? is
shown in the display. The call can be refused
or taken in the normal manner. If the incoming
call is taken, the previous call is put on hold.
Putting a call on hold/resuming a call
1. Press MENU or ENTER .
2. Scroll to Hold or Resume and press
ENTER .
Dialling a third party
1. Put the call on hold.
2. Dial the number of the third party.
Switching between calls
1. Press MENU or ENTER .
2. Scroll to Swap and press ENTER .
Starting a conference call
A conference call consists of three parties that
can talk to one another. Once a conference call
has been initiated, no more parties can be con-
nected. All calls are ended when a conference
call is ended.
1. Start two phone calls.
2. Press MENU or ENTER .
3. Scroll to Join and press ENTER .