98
In case of emergency
Emergency shifting
If a fault occurs which prevents the drive or the revers
gear from being operated (shifted) with the control
lever, it is possible to shift manually, using the des-
cription below.
WARNING
! In emergency shifting, the unit is
locked in forwards operation. Please note that
the drive can not then be disengaged with the
control lever. Forward motion can only be cut
off by stopping the engine with the ignition key
or stop button.
Drives
The drives gears are changed electronically using
a gear lever carrier mounted in the engine compart-
ment
Manual drive engagement
1. Stop the engine and take the starter key out of the
starter switch.
2. Pull out the split pin (1) and lift the adapter (2)
from the pin (3).
3. Place a screwdriver or similar tool in the adapter
(2) hole and move the control wire horizontally.
Reverse gear
This description is for manual engagement of the re-
verse gear, for forward travel.
Note.
The descriptions refer to electrically shifted re-
vers gear.
Manual engagement of the reverse gear:
1. Stop the engine and remove the ignition key from
the ignition lock.
2. Undo the screw (1) on the side
where the cable
harness marked A is connected
.
3. Remove washer (2) and tighten the screw.
4. Undo cables A and B from the solenoid valves.
1
2
A
B
1
2
3
2
Gear forward
Gear backward
Summary of Contents for D4
