Engine Shutdown
Let the genset run at no load for a couple of minutes
before turning it off. This will keep the engine
temperature in balance and prevent it from boiling.
IMPORTANT!
The procedure described above is especially important
if the genset has been run at heavy loads.
IMPORTANT!
If the genset stops abnormally, try to locate the
problem and make the repairs needed before starting
again. After starting the genset, make sure it runs
properly.
Stop the Engine
Emergency Stop
If a fault occurs that prevents the engine from being
stopped normally it can be stopped manually using the
speed adjustment lever on the engine.
1 Move the speed adjustment lever (1) to idle.
2 Move the shut-off lever (2) in the direction of the
arrow until the engine comes to a stop.
The warning display lamps for “No charge voltage”
and “Low oil pressure” will turn on when the engine
stops.
3 Turn the key to position ”0” and remove. The
warning display lamps will turn off.
WARNING!
Working with or approaching a running engine is a
safety risk. Watch out for rotating components and hot
surfaces.
WARNING!
Never try to increase the rpm with the speed
adjustment lever since this will make the engine
overspeed and cause damage.
26
47713337 03-2021 © AB VOLVO PENTA
