18
2
1
3
2
3
4
5
6
7
1
A
B
Lift range
The lift range is used for lifting the drive to its maximum angle,
however this cannot be used during normal operation of the
boat. The range is used mainly for trailer transport of the boat. The
Power Trim has an automatic stop which cuts off the current when
the stop position is reached. The stop is automatically reset when
trimming down.
WARNING! The engine must not be run with the drive in the
“Lift” range.
Digital trim instrument (DP, DP-S)
The display shows the current trim range and drive position. The
same information can be obtained from the LEDs which also indicate
the up or down movement of the bows.
A. Shows the current trim range (TRIM: trim range, BEACH: beach
range, no text on display: lift range).
B. Shows the current drive position* in the range -9 to 42
1. Yellow light indicates that the bows are above the horizontal line.
Flashes when the drive moves and the bow is raised. Otherwise
no indication.
2. Yellow light indicates that the bows are below the horizontal line.
Flashes when the drive moves and the bow is lowered. Otherwise
no indication.
3. Green light comes on in the trim range (-9 to 0). Otherwise no indi-
cation.
4. Green light comes on in the trim range (0 to 2). Otherwise no indi-
cation.
5. Green light comes on in the trim range (2 to 5). Otherwise no indi-
cation.
6. Red light in the beach range (6 to 40). Otherwise no indication.
7. Red light flashes to warn that the drive is in the lift range (over
40). Otherwise no indication.
Note. A diagnostics program is initiated automatically every time the
instrument is activated (using the ignition key); all the LCD segments
light up and the display shows A-BEACH. The instrument then
returns to displaying the current drive angle.
* This figure is the angle of the drive to perpendicular (stationary boat). The lowest
value shows that the drive is trimmed to maximum and the highest value shows
that the drive is at maximum lift. Note that the lowest value can vary from boat to
boat depending on the angle of the boat’s stern.
Analogue trim instrument (DP, DP-S)
The trim instrument indicates the current trim position of the drive.
The scale has five calibration points with the Beach and Lift range
marked in red.
1. Trim range.
2. Beach range (red).
3. Lift range (red)
7740088 - Downloaded from www.volvopenta.com 07/08/2008 11:54:46