VOLTCRAFT V-CHARGE 80GPS, Operating Instructions Manual

Page: 80 / 100

80
• Briefly push the "START/ENTER" button; the deactivation voltage flashes.
• Set the deactivation voltage with the buttons "INC" and "DEC". Keep the respective button pressed for quick
adjustment.
• Briefly push the "START/ENTER" button to confirm the setting.
Proceed as described above to change the discharging current or the discharging voltage again if desired.
• When no display is flashing anymore, keep the "START/ENTER" button pushed (approx. 3 seconds), to start
discharging.
• The charger now examines the connected rechargeable battery. In case
of an error, a warning signal is output and the corresponding information is
displayed. You can stop the warning signal by pressing the "ESC/MODE/
STOP" button. You then return to the previous configuration menu.
If no error is found, e.g. the display shown on the right will appear.
The rechargeable battery type is displayed in the upper left of the display,
the upper middle shows the discharging current and the upper right the
current rechargeable battery voltage.
The lower left shows the current rechargeable battery programme, in the middle the elapsed charging time and
the charged capacity in mAh are displayed to the right of this.
• After completion of discharging, an audio signal is emitted (if it has not been turned off).
If you wish to cancel the discharging process, push the "ESC/MODE/STOP" button.
e) Cycle Programme ("CYCLE")
To test rechargeable batteries, form new rechargeable batteries or refresh older rechargeable batteries, you can
perform up to 5 cycles in sequence automatically. The two possible combinations are "Charge/Discharge" and
"Discharge/Charge".
Proceed as follows:
• Set the rechargeable battery type as described in chapter 12. a) (NiMH or
NiCd) and select the rechargeable battery programme "CYCLE".
The set rechargeable battery type is shown in the upper left of the display,
and the rechargeable battery programme in the middle.
The display at the upper right represents the corresponding combination "Charge/Discharge" ("C>D") or
"Discharge/Charge" ("D>C"). The charge current ("C") is shown in the lower left, the discharge current ("D") in the
middle and the number of currently set cycles in the lower right.
Use the buttons "INC" or "DEC" to select a different rechargeable battery programme; use the button
"ESC/MODE/STOP" to return to the main menu.
• Push "START/ENTER" to change the settings. The order for the cycle programme ("C>D" or "D>C") flashes.
NIMH CYCLE C>D
C=1.0A D=1.0A 1
NiMH 2.0A 7.42V
DSC 022:45 00690
BATTERY CHECK
WAIT...